http://www.msdignition.com/downld1.htm

http://www.msdignition.com/pdf/6%20series/6series.pdf

You should be able to wire up about anything w/ that

well i didnt want  to buy a kit, but it looks like its the easiest way to do it right..

Think this would be a good price for a kit
http://www.jegs.com/p/MSD/760635/10002/-1/76248
2sav

2Sav,
 Not a bad price. I saw a post from you at PB.com that you are selling your boat.
What's the deal. Are you getting it wet first. Why for sale.
  T.J.

  Because im tired of seeing all these boats go up and down the river, and a bunch of them for sale turn key for under $4000   I wanna play too......But after thinking long and hard and a bunch of beers later... Im going to keep her and finish this bitch off.....

Im just frustrated, and now drunk so its all good........................

2sav

  Because im tired of seeing all these boats go up and down the river, and a bunch of them for sale turn key for under $4000   I wanna play too......But after thinking long and hard and a bunch of beers later... Im going to keep her and finish this bitch off.....

Im just frustrated, and now drunk so its all good........................

2sav

I know what you mean 2Sav. I was in the same situation. There were tons of nice less expensive boats on the market when I was doing my boat. There was a place in AZ I think it was Doc's place (I have been there and met Doc in 2005). Once in a while they would post a killer Jet on E-bay. They were great deals too. Even my wife was like get rid of your forever ongoing project and get one of those (I am in CT and the trip would be $$$). I was frustrated too, but kept on plugging away at it. You are close man, don't give up man. It took me 4 years to get my boat to where it is today and tons more money than a turnkey boat.
I kept going cause I knew I would "know" my boat when done. Now get that bitch wet.
Good luck.
  T.J.
ps- I have almost 1k into my MSD set up. Pro-billet dist, 7AL2 Box and Pro-blaster coil and Taylor wires.
  T.J.

'80 Nordic just baught a Mallorey Sprintmag for $128.50, and Rod got a Sprintmag II for a couple hundo....I got $500 in my new MSD Promag.

jus slap an HEI in it and go, one wire, more than enough. I dont think that motor will spin hard enough to need a limiter, (valve springs). All that shit can be added later. Summers half over Dog, lets go.

You read my mind brotha........im gonna buy wanna them cheap Pro Comps off ebay

I like the one wire thingy Boat will be wired in a few days, just installed the new ignition and bilge switch..
Its time to ROCK

2sav

2Sav,
  I have an HEI set up. GM module (not china) new cap rotor and good coil. I used this to break in my BBC on my run in stand. 50 bucks plus shipping. Otherwise I am putting it on Ebay.
T.J.