Pulling motor out

« **on:** June 16, 2015, 06:52:48 PM »

I know this may sound really stupid. The day cruiser I bought a while back, I decided to pull the 460 out and give it a good check out. However I can not get the motor to come off the spine to the pump. What am I doing wrong? Does it not just slide off as it appears it would do? Any help would be appreciated

« **Reply #1 on:** June 16, 2015, 07:09:02 PM »

Yup... Just hold your mouth just right and wiggle wiggle wiggle... Don't lift it to high... Should just have to lift it a tad higher than where the original motor mount bolts were

Sent from my iPhone using SoCal Jet Boats

« **Reply #2 on:** June 16, 2015, 07:10:40 PM »

It slides off, if it's been on there a long time it could be seized.

Is it moving at all?

Sent from my iPhone using SoCal Jet Boats

« **Reply #3 on:** June 16, 2015, 08:16:22 PM »

The splines could be twisted.

Whack the snot out of it with a hammer using a block of hardwood.

« **Reply #4 on:** June 17, 2015, 07:52:05 AM »

thank you for the suggestions it sounds like I need to just give it a little bit more persuasion going to try it again tonight I'll let you know how it goes

« **Reply #5 on:** June 21, 2015, 07:21:22 PM »

Thanks to you all. It just needed a little encouragement. She finally came out. Appreciate the help.

« **Reply #6 on:** June 21, 2015, 08:26:19 PM »

If it was that hard to remove, check the splines to verify that the shaft is indeed not twisted and that the yoke slides freely.

outofhours

Pulling motor out

Blue2184

Re: Pulling motor out

philofab

Re: Pulling motor out

GT Jets

Re: Pulling motor out

outofhours

Re: Pulling motor out

outofhours

Re: Pulling motor out

Flusher

Re: Pulling motor out