Wiring color codes

« **Reply #25 on:** March 14, 2009, 11:53:33 AM »

Quote from: IRRebel on March 10, 2009, 11:26:09 PM

Ummmm, (Hand Raised), I have a question........If you'uns don't mind.

Why does MY boat's factory harness not match the color code either?

Twas why I researched every friggin wire in the thing with a DMM and was puzzled why the Oil Pressure guage went nuts.

I'm with 2Sav, make all the wires the same color and make the next Baztard figure'em out!

Ray

Can't believe you don't know the answer to that..........The guy was Cow blind..

Sorry for another jack. $:-\$

Steve, why don't you make your own cables? It's really easy, you need some heat shrink tube, the cable, and an inexpensive hammer blow crimper for welding cables (like $12), you can buy the really nice copper cable lugs for the correct size wire and make a cable in about 10 min., I have been doing my own for 20 years. If you really want to get trick, you can tinn the cable lugs when they're crimped with a trigger torch and some rosin core solder, they look really professional when finished, I'll dig up some pics...BTW got the bolts, Thanks much..more than happy

GT

« **Reply #26 on:** March 14, 2009, 12:28:29 PM »

Good to hear Glenn

They only charge $4.75 foot + connectors and if i can buy a cable premade of the rack i will but the one im having made is only about 8"s long from solenoid to starter....

So do all the wires hook to one side of the terminal ?

« **Reply #27 on:** March 14, 2009, 01:15:17 PM »

Quote from: 2savage4you on March 14, 2009, 12:28:29 PM

Good to hear Glenn

They only charge $4.75 foot + connectors and if i can buy a cable premade of the rack i will but the one im having made is only about 8"s long from solenoid to starter....

So do all the wires hook to one side of the terminal ?

I don't know what you mean, all what wires? The mains should be all by themselves due to the wire size, they would have to be fused if there are smaller wires coming off the mains, I am positive I misundertood the ?

GT

« **Reply #28 on:** March 14, 2009, 01:25:04 PM »

Quote from: 2savage4you on March 14, 2009, 11:35:53 AM

Ok now im getting cables made for this set up on monday and just want to double check.. i dont want cables made and they end up being to short/long

So on this diagrahm it shows the wire to power the boat,alt, Batt cable, and starter cable all on one terminal.... Is this correct ?

I had an old tbird and the battery cable and starter cables were one on each side of the soleniod , maybe im over thinking this again..

Boat is completely wired except for battery and starter cables

And no , you wont find no purple wire on my boat

Quote from: GT Jets on March 14, 2009, 01:15:17 PM

So do all the wires hook to one side of the terminal ?

I don't know what you mean, all what wires? The mains should be all by themselves due to the wire size, they would have to be fused if there are smaller wires coming off the mains, I am positive I misundertood the ?

GT

Im just wondering cause if all cables go on one terminal , its gonna be a tight fit.... But i like it tight

GT Jets

Re: Wiring color codes

2savage4you

Re: Wiring color codes

GT Jets

Re: Wiring color codes

2savage4you

Re: Wiring color codes