Transom plate has half moon notch got clean out too

Is there a benefit to adding aluminum rails?

makes it easy to install and remove, and has a little cool factor as well

makes it easy to install and remove, and has a little cool factor as well

I have enough material to make one for you bud just tell me the lengths it was cheaper to buy it at full stock than pre cut I will hook you up bud no charge just gonna b my version not like the rest plus I have a pattern for motor plates I'm gonna make next. I can build a rail kit for a tenth of what everyone is charging let me know

Looks like I'm gonna b buying a mill and lathe roto phase next three phase on the garage time to make some cyclone speed marine b1 racing mpd g&s parts for me self thank you so called Uncle Sam

Finally convinced my pops on letting me have my grandfathers mid 50's Bridgeport matching mill and lathe. It's been collecting dust in his garage for a while. Got some more work done put a radius on the the rails and hit the drill press and drilled all the mounting holes. Now to make some motor plates feet and a pump brace

Thanks slow but it's progress

Any progress?