What is flocoating? I didn't even think about sanding it.


Sent from somewhere in Cali

The flow coat is a 1:1 mix of gel and clear. Below is a pic of the clear I used. Some people will just do the clear and leave the wood/fiberglass floors exposed or they'll mix a color into it like I did.

The company I purchased everything through is: http://www.sherfab.com

I forget who I talked to there, but they gave me good advice on how to prep and spray the stuff. I was very happy with the results.


Sent from my iPhone using SoCal Jet Boats

Carpet every where you walk and flow coat everything else

Man now I'm not sure what I want to do flow coat looks bad ass. I just have a lot of old glue on the floor not sure if I want to scrape it all off.


Sent from somewhere in Cali

Pull all the old carpet out and then pressure wash it. The pressure washer will get pretty much all the glue off then go and sand everything like your suppose to and spray.

Pull all the old carpet out and then pressure wash it. The pressure washer will get pretty much all the glue off then go and sand everything like your suppose to and spray.

Looks like I have some work cut out this winter.


Sent from somewhere in Cali

I used rustoleum in my engine bay
 Looks good to me. Its holding up good. I just rolled

I have rustoleum in my Kachina after three seasons it's starting to flake off a little.

I used rustoleum in my engine bay
 Looks good to me. Its holding up good. I just rolled

Good to know. I don't think I want to keep my boat much longer than 5 years before I up grade.


Sent from somewhere in Cali