Remove two Allen bolts on either side of the bell housing that sits on the jet.
This will release the lower bracket that holds the bell housing in place.
Then raise the engine slightly and push the engine forward, towards the bow. The drive shaft is a slip fit on the splines of the jet shaft.

There's no need to disconnect the driveshaft prior to engine removal.

Hope this helps


Sent from my iPhone using SoCalJetBoats

X2 instructions from rushineliminator17 are dead on

Ya driveshafts are u joit set ups so jack the block up just enough so the engine is free swinging ang slide forward until it's off the jet drive shaft, and everytime I ever put the motor back in, you do exact opposite, lower it down to close to where it mounts, then slide driveshaft onto the jet drive splines, then bolt motor back up..... An engine sling is a def plus


Sent from my iPhone using SoCal Jet Boats