Impeller issue

« **on:** May 09, 2016, 05:25:36 PM »

I bought a used impeller, and while it is an "A", and does fit, sorta...
It doesn't allow the bowl to go on, holding it out by a half inch. Will machining off a half inch from the bowl side make it work?

Sent from my iPad using SoCal Jet Boats

« **Reply #1 on:** May 09, 2016, 06:09:47 PM »

Quote from: shadow3621 on May 09, 2016, 05:25:36 PM

I bought a used impeller, and while it is an "A", and does fit, sorta...
It doesn't allow the bowl to go on, holding it out by a half inch. Will machining off a half inch from the bowl side make it work?

Sent from my iPad using SoCal Jet Boats

No, you will need to obtain a Dominator bowl or have the rear of the impeller machined off. Not the bowl.

GT

« **Reply #2 on:** May 09, 2016, 06:36:54 PM »

OK, sorry GT, I meant the bowl side of the impeller. Thank you very much, as always, your advice is appreciated.

Sent from my iPad using SoCal Jet Boats

« **Reply #3 on:** May 09, 2016, 06:38:17 PM »

You can also bore a Berkeley bowl for the second wear ring

« **Reply #4 on:** May 09, 2016, 07:56:04 PM »

The impeller that I am using for now is a temporary thing. I will be buying a new impeller at the end of the season, so I will just have it machined.

Sent from my iPad using SoCal Jet Boats

« **Reply #5 on:** May 19, 2016, 09:19:18 PM »

since you apparently bought a used impeller for a different brand pump be sure to verify all your clearances/tolerances to insure everything works correctly. Do you have a shouldered wear ring?

shadow3621

Impeller issue

GT Jets

Re: Impeller issue

shadow3621

Re: Impeller issue

Flusher

Re: Impeller issue

shadow3621

Re: Impeller issue

damfoo

Re: Impeller issue