How bad is this?

« **on:** April 27, 2014, 12:18:08 PM »

This doesn't look good a lot of bronze wonder if this could be the cause of my idle overheating

Sent from my iPhone using SoCal Jet Boats

« **Reply #1 on:** April 27, 2014, 12:25:02 PM »

Here

Sent from my iPhone using SoCal Jet Boats

« **Reply #2 on:** April 27, 2014, 01:22:09 PM »

Something is pretty loose... And yes, the cause for the overheat IMHO.

« **Reply #3 on:** April 27, 2014, 02:09:34 PM »

The nut holding the impeller came loose it was hand tight, I figure this pump is shot?

It had no punch out the hole whatsoever at 2500 it just planed till about 3500. After parking and going back out the temp would shoot to 200 in the no wake and keep climbing till I would take off

Sent from my iPhone using SoCal Jet Boats

« **Reply #4 on:** April 27, 2014, 10:20:07 PM »

Will adding the epoxy fix this issue? It has excessive play

Sent from my iPhone using SoCal Jet Boats

« **Reply #5 on:** April 27, 2014, 10:29:52 PM »

Marine Tex http://www.marinetex.com/marinetexepoxyputty.html , Belzona 1111 http://www.belzona.com/en/products/1000/1111.aspx

Either will do the job, Belzona is for ballers, or for guys who steal the sh!t from work.. $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$

GT

jquizy

How bad is this?

jquizy

Re: How bad is this?

GT Jets

Re: How bad is this?

jquizy

Re: How bad is this?

jquizy

Re: How bad is this?

GT Jets

Re: How bad is this?