I recently added a droop to my WJ. I mocked it up last week and ran into a bit of a snag. The forward/reverse cable is smaller than the opening on the PD bracket. The PD is a FTN version. When I think about it my previous WJ diverter had a set screw that went into the PD bracket to hold the cable in there snuggly. This bracket seems not to have one. This is my first time dealing with a Berkeley style PD. Am I missing some hardware here? Pics would be appreciated of your set up. I am thinking a reducer grommet can be put in there but I’m not sure how safe that is.     

if your that worried about it i will take the WJ one off of your hands!!!  lol

Hmmm it seems as if your cable is thicker. Did the WJ use different F/R cables as opposed to Berkeley?

Would a grommet work here?

Mine look similar.(to each other)

Whats the dia. of the threaded end? or is there a threaded end? (cable housing at diverter)
I think the "handle" end used a 2-bolt hold down. more pics of the orig. setup & cable end would be helpful

Daniel
Mash on it

Here's pics of when the WJ diverter was on there. Notice there are no nuts on either end but a set screw that goes into the arm to secure the cable. (pay no attention to the red circles)

The number on the cable is  D32377-003-0156.0. I'm guessing the 0156 is just length.

Wj and Yj Jacuzzi's used the smaller  33 series fwd rev cable , Place designed the WJ diverters to "retro" fit the jet and re use the original Fwd Rev cables the diverter pictured is made to use a 43 BC (bc= bulkhead conn) so you have 3 choices , the "Janky" hose clamp deal  , upgrade thre cable to a 43 Bc (requires a piece @ the shifter) or we sell a small billet cable adaptor that will pass thru the large hole and facilitate the 33 cable (very clean) Call if you need help Tom