No heated garage for the Jet this winter.
Question about purging all water out of bowl. (Berkeley Jet Drive)

Does the water settle to the bottom of the  bowl (water on bottom, oil floating on top)
like it does on an outdrive?

If so, with no drain on bottom how can I be sure I've got all the water out to prevent freeze problem.

Thanks,
Bob

Thanks GT!

Got Block & exhaust (everywhere water is supposed to be) covered to 20 below!

Wanted to find drain on bottom of bowl to check for water.  Since the Berkeley maintenance literature
says ...

Use 90 wt.gear oil check every 2 month or 100 hours of operation. To refill the bowl oil remove both of the 1/8" npt plugs on the bowl and using a squeeze bottle of oil force oil into one of the hole still it comes out the other,re-install both of the plugs. You may notice after a while that the bowl bearing area is full of water and not oil. This is a satisfactory condition, (it is best to keep full of oil) as water will leak past the seal, except that this water could cause structural damage to the bowl if permitted to freeze. For winterizing always re-fill with oil before lay-up of the boat.Both oil and or water will both lube and cool the tail shaft bushing at higher rpm levels. The bowl seal is more designed to keep the water out than the oil in as it is installed towards the pressure of the water. The seal will keep the oil or water mixture in the bowl area when the boat hauled out of the water as well.


I guess it must not be that scary of an issue or there would a more definite way to check/correct.

The MRS's car has wintered outside since a got the Carrera.
I only pushed the jet to the "cold" garage because my son and I have a couple vintage bike projects to work on this winter.  (note to self: Don't let the wife see this post) Lol.

Bob