Is there a part I can buy (spacer) that will twist the carb to not be diagonal


Sent from my iPhone using SoCal Jet Boats

Lol thanks GT
I just didn't know if there was such a piece. Looks like the intake manifold stays. Paint this weekend and install Monday or Tuesday. 


Sent from my iPhone using SoCal Jet Boats

Is there a part I can buy (spacer) that will twist the carb to not be diagonal


Sent from my iPhone using SoCal Jet Boats

sweet manifold lol, I just ran a 1" spacer with it, I still have the throttle cable bracket if you need that as well👍🏼


Sent from my iPhone using SoCal Jet Boats

I may need a throttle cable bracket


Sent from my iPhone using SoCal Jet Boats

What's your take on engine enamel to paint the intake manifold?


Sent from my iPhone using SoCal Jet Boats

I've used the appliance epoxy- black for motors. There isnt really enough heat in the intake to bother paint, so use any color of shake-n-shoot you like. Automotive paints have been used, too. Just remember, any fuel spilled will damage the finish.

Sand/media blasting is a good alternative, and leave 'raw', just mask off all the gasket surfaces before blasting. 

Dan'l

I've used the appliance epoxy- black for motors. There isnt really enough heat in the intake to bother paint, so use any color of shake-n-shoot you like. Automotive paints have been used, too. Just remember, any fuel spilled will damage the finish.

Sand/media blasting is a good alternative, and leave 'raw', just mask off all the gasket surfaces before blasting. 

Dan'l

Ok sweet! So any paint will be ok? It's really just for this season I'm looking into getting a different hull so one I do I'm pulling my motor and I'll do some more work to it.


Sent from my iPhone using SoCal Jet Boats

I have that manifold on my wife's mini day cruiser 👍 mild built 468 Chevy made motor perform well...


Sent from my iPhone using SoCal Jet Boats

What you trying to say it's a woman's manifold? Lol


Sent from my iPhone using SoCal Jet Boats