Almost done with the pump rebuild

Made this harness at work today. Fabricating more for BBC. Pm if interested


Sent from my iPhone using SoCal Jet Boats

Pulled the motor, gotta fix a pesky oil leak.

The rear main? Fix that Bruce and you will be even more badass

Looking at it now, I can't tell if it's the main or the pan gasket. I don't want to pull the crank if I don't have to  so need to figure it out.

Pan gasket would be good news

Almost done with the headers. Just gotta finish plumbing.

The last Pic Of The Bubble Gum Machine!!! New Color Starts N about 1 Hr!!! Can't Wait Baby long day But Worth It!!! Hope 2 make U Guys Proud Of This Member here N The Lou!!👍🏻👍🏻


Sent from my iPhone using SoCal Jet Boats

Sexy yo!

Is that a falcon sprint in the back ground


Sent from my iPhone using SoCal Jet Boats

64 Futura project.

Just got my new nozzle droop and ride combo installed.

Still have to install it snail mail up here in Canada.

Finished external drain lines..

Just an FYI, flare fittings and AN are different angles.  Did you use copper O-ring on the brass to aluminum?

Trying to save you a leak or two.

GT

Oh crap. I didn't know that. Where do I get the o-rings? Now that I look at my plumbing I see I've got some other flare fittings including on my fuel lines. Haven't had any leaks yet..

Earl's makes a copper crush gasket, a refrigeration supply house will have some too. It's not the best fix,  but may save you some grief.

Standard flare is typically 45°, whereas AN is 37°.

GT

The pump is getting a make over