460 wiring question

« **Reply #25 on:** May 13, 2015, 08:09:16 PM »

Here is a pic of it

« **Reply #26 on:** May 13, 2015, 08:11:02 PM »

Here it is

« **Reply #27 on:** May 13, 2015, 11:47:59 PM »

I'd be a little concerned about the gear on the cam too. If it was mine I'd probably at least make sure to shine a light down there and take a look at the cam gear.

Sent from my iPhone using SoCal Jet Boats

« **Reply #28 on:** May 14, 2015, 07:29:32 AM »

I did as soon as I saw the gear on the dizzy the gear on the came looks OK there is a little mark on it the other than that it looks ok

« **Reply #29 on:** May 14, 2015, 07:55:19 AM »

Do you have a high volume and/or pressure oil pump? Without proper bearing clearances, that will wear the distributor gear.

You might need to shim your distributor for proper alignment.

http://www.chevyhardcore.com/tech-stories/ignition-electronics-efi/selecting-the-correct-distributor-gear-its-all-about-the-details/

« **Reply #30 on:** May 14, 2015, 09:58:32 AM »

I do not know I didn't build it the engine appears fresh but the guys I got it from said it was built right before he got it he said he ran it then it just sat for two yr now I know why it. There a way to tell with out pulling the motor

monster burb

Re: 460 wiring question

monster burb

Re: 460 wiring question

tamsone6

Re: 460 wiring question

monster burb

Re: 460 wiring question

Flusher

Re: 460 wiring question

monster burb

Re: 460 wiring question