Need 454 rebuild

« **on:** March 24, 2013, 12:26:54 PM »

Any know a place close to chino ca

« **Reply #1 on:** March 24, 2013, 01:16:59 PM »

Are you looking for just a stock rebuild?

Barry - Obnoxious001 here on the forum, builds motors and he is in Glendora. Not to far.

I'm sure there are places closer, but you want to make sure they have experience with jet boat motors.
Marine motors should run different bearing clearances than a regular car motor.

« **Reply #2 on:** March 24, 2013, 01:40:51 PM »

I have a machine guy that I always take my engine too he's in Norco it's d&r machine his name is Dennis 9515334493

« **Reply #3 on:** March 24, 2013, 03:01:53 PM »

Sweet thanks guy I will check them out

« **Reply #4 on:** March 24, 2013, 03:10:41 PM »

Do you guys know how it's going to cost

« **Reply #5 on:** March 24, 2013, 04:16:08 PM »

Check out jms racing in El Monte not to far they have my 496 on the dyno now and my brothers 454 they punched to 462 cost was 3500. Not to bad with new cam lifters rockers and pan and it was ran on there dyno. Ask for Mike he's the owner great Guy tell him David and Jeff sent you he will take care of you

« **Reply #6 on:** March 26, 2013, 11:28:48 PM »

Quote from: TrollerDave on March 24, 2013, 01:16:59 PM

Are you looking for just a stock rebuild?

Barry - Obnoxious001 here on the forum, builds motors and he is in Glendora. Not to far.

I'm sure there are places closer, but you want to make sure they have experience with jet boat motors.
Marine motors should run different bearing clearances than a regular car motor.

Thanks Dave, that's correct, boat engines need to be built more like a race engine since they get run so much harder than an engine in a street vehicle. Not super magic,, just need everything to be right so it will live.

Jetboat909

Need 454 rebuild

TrollerDave

Re: Need 454 rebuild

carlitos

Re: Need 454 rebuild

Jetboat909

Re: Need 454 rebuild

Jetboat909

Re: Need 454 rebuild

DDP1084

Re: Need 454 rebuild

obnoxious001

Re: Need 454 rebuild