Question, I'm rewiring my boat, and getting rid of the stock terminal breaker block. I'm going to put a inline 35 amp block fuse. My question is on the terminal block, I can't find a 35amp only 25 then jumps to 45amp.

What amp terminal bar should I get? Or anyone know where I can get a 35 amp terminal block. Thank you in advance.


Sent from my iPhone using SoCal Jet Boats

Question, I'm rewiring my boat, and getting rid of the stock terminal breaker block. I'm going to put a inline 35 amp block fuse. My question is on the terminal block, I can't find a 35amp only 25 then jumps to 45amp.

What amp terminal bar should I get? Or anyone know where I can get a 35 amp terminal block. Thank you in advance.


Sent from my iPhone using SoCal Jet Boats

The breaker protects the wire, so it should be sized accordingly.

GT

When I build my harnesses I never used the terminal block route. I would use the packard weather proof connectors for everything of course wires sized and colored to the boating industy association. It was plug and play when removing the engine.
T.J.

When I build my harnesses I never used the terminal block route. I would use the packard weather proof connectors for everything of course wires sized and colored to the boating industy association. It was plug and play when removing the engine.
T.J.

  I agree makes life simple and easy to pull the motor.

No sir look up weather pack


Sent from my iPhone using SoCal Jet Boats

I personally would stay away from the GM/ Delphi weather pack connector. I like using the Deutsch connectors, the terminals have a way better locking design inside the connector housing. I've seen countless failures with the terminals inside the housings on the GM weather packs.


Sent from my iPhone using SoCal Jet Boats

I personally would stay away from the GM/ Delphi weather pack connector. I like using the Deutsch connectors, the terminals have a way better locking design inside the connector housing. I've seen countless failures with the terminals inside the housings on the GM weather packs.


Sent from my iPhone using SoCal Jet Boats

. Each there own. Been using them for years no trouble so far.


Sent from my iPhone using SoCal Jet Boats

Very nice. That's wire porn

I'm kind of a wiring nut though. Here's a dash I just did a last week for a customer.  Personal message me if I can help in any way.
Cheers!


Sent from my iPhone using SoCal Jet Boats

Are you located around the inland empire?


Sent from somewhere in Cali

I'm kind of a wiring nut though. Here's a dash I just did a last week for a customer.  Personal message me if I can help in any way.
Cheers!


Sent from my iPhone using SoCal Jet Boats

Hey bud, doing the re wire and want to use a aux solenoid, What solenoid should I get? This is the diagram I'm using to rewire, and I'm 30 amp reset breaker, running 14 gauge instead of 16 because I already had, and using 10 where it's listed to use. Thanks in advance. 


Sent from my iPhone using SoCal Jet Boats

Ok thanks!


Sent from my iPhone using SoCal Jet Boats

I'm kind of a wiring nut though. Here's a dash I just did a last week for a customer.  Personal message me if I can help in any way.
Cheers!


Sent from my iPhone using SoCal Jet Boats

Wow,


That's some clean work man.  I dig your attention to detail….


You using that copper as a bus?


G

Wow,


That's some clean work man.  I dig your attention to detail….


You using that copper as a bus?


G

Thanks, and yes I am using the copper as a bus. It gets one heavy gauge wire to power the dash panel


Sent from my iPhone using SoCal Jet Boats