Ill check when I get home. Might have an extra set with screws for those valve covers.

Well its a ford, so you should expect it to spit and drip oil from all over the place anyway😂😂😂😂


One fast station wagon!!!

Sorry bud, found all eight screws but only could fricking find one baffle plate.

Make your own plate... thin piece of scrap metal from the local metal supply might be a buck. I made some stainless for my holley 460 covers for .50. Red lock tight... Are you running at least a 1/2+ qt low from max?

 


Was thinking the same thing. Ill even send you the one plate I have as a template you can use plus the screws.

Your mom, that was my plan if I could not find any. I'm running 6qts in a stock pan.

Ford lover that would be bad ass, would make it much easier!


Sent from my iPhone using SoCal Jet Boats

Pm your address and Ill send it.

Fordlover Pm sent! Thank you!!!

Hahahah Josh you crack me up with your savageness


Sent from my iPhone using SoCal Jet Boats

I love all three of my Ford's

That looks kick ass! Good job!

So your running 6qts in a 6qt pan? If so take 1/2qt out. If you have a stock dip stick, keep the reading roughly in the middle. I'd consider getting a 10qt pan an run 9. If you have over trans headers you could install a evap or puke tank.

So your running 6qts in a 6qt pan? If so take 1/2qt out. If you have a stock dip stick, keep the reading roughly in the middle. I'd consider getting a 10qt pan an run 9. If you have over trans headers you could install a evap or puke tank.

Yea, I am running the stock pan with the full amount of oil. I want to get a 10qt I just have to measure the clearance it's pretty tite in There. I bought a puke tank it came in and it's way to small. With the baffels in no oil comes out of the valve covers anymore. I went for a quick test this after noon not a drop of oil came out.


Sent from my iPhone using SoCal Jet Boats