Thot I had seen a thread when I was lurkin on HB, but thats out the window. Does anyone know where they sell em? Im lookin to get on for my 76 Nordic. One other question I had was does anyone know if the early Nordics came with the metal nordic insignias on the sides, thot I saw a pic with them about a year ago but dont remember where

question is something like that $$$$$. or $ ?

76,
  Here is a pic of my splash guard. I guess the previous owner put a hole in it for the bilge hose. I will TIG that up in the Spring maybe. I also want the badges like 1980Nordic has. My boat has the indents for them too.
  T.J.

what the hell call Nordic....ya never know.......stranger things have happened.....

yea sorry guys no luck on the badges if they were glued on i would hook you guys up one for each of you but since they screw into the hull i dont want holes ya know usually everything i own i debadge any vehicle and whatever else into that clean look but like i said holes exhist something has to go there......however i tend to run into alot of stuff so i'll tell ya if i run into something

Yesterday I went by Finnely's here in Havasu to see about splash Guards....let's put it this way....I had to pull the shorts out of my ass after he told me it would cost 350 bucks........F that....I'll freakin make my own.....I can imagine what his powder coating costs.....

I think thats a reasonable price for custom plastic work.

i got mine from bergeron engineering out in mesa (az), it has been a couple of years ago, but it was only like $100.00 +- a little, that was for the plastic one in the smoked color

Bergeron Engineering
1559 n Country Club
Mesa, Az 85201-2513
480-834-1531

The one i got was kinda a universal fit??, no holes drilled or anything and flat, i had to clamp it to the boat, make the bends and drill the mounting holes, not very hard to do at all, it was nice though because i could decide how high i wanted it to go, it fits very nice except in the corners, there is just a small gap, not noticable unless you look straight down at it and it does not allow very much water to enter there. i would buy the same thing again

I sell my custom make and fit splash guards for 450, but was giving Al a deal. I don't have to justify my pricing to anyone, but if you are looking for a cheap deal I have a flat fit most 1/8 lexan for 100.00. Rodger Finney, Finney Plastics and Powder coating, Lake Havasu

I need to get with you about clear powder coating my new engine mounts


2sav

Roger and David have done some real nice work for me, they are who I use for all my powder coating here in the Mohave County Area !

Try L&L Marine in Corona Ca.

www.llmarine.com  the link at the top right for windshields will get you there

did you try this??

http://www.llmarine.com/content/llmarine/boatwindow.htm