Berkeley Thrust Bearing Over Greased

« **on:** May 22, 2017, 03:24:44 PM »

Took a look through the inspection hole in front of the thrust bearing on my Berkeley jet and there appears to be quite a bit of grease visible....almost as if it has been over greased. Should I be concerned? If so, what is the easiest way to clean it up to make sure its not over greased?

« **Reply #1 on:** May 23, 2017, 08:25:42 PM »

Pictures of said inspection hole

Sent from my iPhone using Tapatalk

« **Reply #2 on:** May 24, 2017, 09:50:04 PM »

Anyone?!?

Sent from my iPhone using Tapatalk

« **Reply #3 on:** May 24, 2017, 09:56:09 PM »

I wouldn't worry about it too much. If it's overgreased it will probably just sling out.
Otherwise you will have to take it apart to clean it up.
Probably more important to make sure that it isn't under greased.

Sent from my iPhone using SoCal Jet Boats

« **Reply #4 on:** May 24, 2017, 10:01:44 PM »

Don't worry about overgreasing it. It's good to flush moisture out of the bearing after each trip. Yes, it makes a mess, but it's better than losing a thrust bearing, followed by an impeller, suction housing, and crankshaft.

« **Reply #5 on:** May 25, 2017, 07:21:36 AM »

Quote from: Flusher on May 24, 2017, 10:01:44 PM

Don't worry about overgreasing it. It's good to flush moisture out of the bearing after each trip. Yes, it makes a mess, but it's better than losing a thrust bearing, followed by an impeller, suction housing, and crankshaft.

Thank you! I'm just going to throw some tape over that hole for the first run and will reassess after that.

Sent from my iPhone using Tapatalk

king295

Berkeley Thrust Bearing Over Greased

king295

Berkeley Thrust Bearing Over Greased

king295

Re: Berkeley Thrust Bearing Over Greased

Steveo909

Re: Berkeley Thrust Bearing Over Greased

Flusher

Re: Berkeley Thrust Bearing Over Greased

king295

Re: Berkeley Thrust Bearing Over Greased