hardline for gate

« **on:** June 23, 2012, 03:33:25 PM »

whats up guys, i attached some pictures below... what do i need to do to make a hardline/pipe for the fitting through the transom from pump to attach my gate valve onto? im trying to install a gate valve and i need a solid pipe to install it on. any way to install the pipe onto the fitting i already have? trying to get the boat in the water by next weekend

lineee.jpg (0 kB - downloaded 561 times.)

« **Reply #1 on:** June 23, 2012, 06:58:12 PM »

I don't think you'll be able to hardline to that fitting. You could run a short connnector hose to a gate valve that is equipped with a hose barb on one side then do whatever you want on the engine side.

Get a good piece of Green stripe Gates or something thick walled to support the weight of the valve (not standard automotive heater hose).

« **Reply #2 on:** June 23, 2012, 08:02:53 PM »

I suppose I will go that route.... thanks chief

Tomanyprojectz

hardline for gate

crewchief22

Re: hardline for gate

Tomanyprojectz

Re: hardline for gate