Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - joinerboy

Pages: [1]

Jet Pumps / Place diverter/droop kit

« on: May 13, 2014, 07:24:11 PM »

Does anyone know if theres somewhere i could buy a droop or mini droop with a place diverter kit like all one package? And would i need a ride plate for a droop or mini droop? And is a mini droop a real thing haha. A buddy mentioned it but ive never seen one. All tips would be sweeet!

Sent from my iPhone using SoCal Jet Boats

Engine Mechanical / Electrical / Fuel lines

« on: May 10, 2014, 11:51:09 AM »

Ok so my fuel lines are leaking. But i CANNOT get them loose from the tank. There is no room in there to get a wrench in there and i just cant figure it out. The tanks are plastic and i think to remove them you have to cut them out. Any tips/tricks?

?

Sent from my iPhone using SoCal Jet Boats

Engine Mechanical / Electrical / Bbc rear main

« on: April 22, 2014, 08:44:07 PM »

Got the new/used motor in boat. Took the the lake and rear main is dumping oil in the boat. Its a stock 454 out of an 83 truck. Anybody know if this is a one or two piece seal?? Either way im pulling motor back out to do it just wondering how much of a PITA im looking at.

Sent from my iPhone using SoCal Jet Boats

Engine Mechanical / Electrical / Oil pressure gauge

« on: March 20, 2014, 05:34:33 PM »

I have a gaffrig II oil pressure gauge. I used the sending unit that was already on the motor. (Stock gm) the gauge just pegs out to 80 when key is turned on. Do i need a gaffrig sending unit or is something wrong? Ive tried to figure out if i have a wire crossed but all wiring seems correct.

Sent from my iPhone using SoCal Jet Boats

Engine Mechanical / Electrical / Bbc cam?

« on: March 15, 2014, 02:37:19 PM »

I am putting a stock 454 out of an 83 rv into my southwind. I want to toss a cam in it just to give it a good choppy idle. Not expected a whole lot out of the motor as far as speed its just a lake boat for now. Whats a good sounding cam that doesnt require changing the valve springs and all that. Just cam and lifters.

Sent from my iPhone using SoCal Jet Boats

Boat Showcase / New member new jetboat

« on: March 12, 2014, 07:06:23 PM »

71 southwind. Came from san diego area. I am located in south carolina. Sucks over here. Out there seems so much better. Wanted to get opinions/input as well as if anyone recognized the boat and who did the restoration. I destroyed a piston this weekend and it will be getting a newer bbc this week. Please comment and give me input.

Sent from my iPhone using SoCal Jet Boats

Pages: [1]