.060" over srp 18cc dome pistons, scat h-beam rods, rpm 4340 crank (was skeptical, but this is a very noce piece) deck height is at zero, mains set at .003-.0033, rear main is at .004, rods ar .0022...gotta find my notes to see where i set the rings and thrust. 4 bolt mk IV block, arp main studs, arp head studs, .650 lift bullitt solid roller, isky lifters, std length t-chain (and its tight) clevite bearings, rpm balancer, b&d 10qt oil pan, melling hd oil pump.
i've also got set of dart pro-1 310cc aluminum heads with brand new valve seats installed. i've got new valves and all the pieces, just need a valve job and they're ready to go.
dart single plane intake and a holley 1050 that i just went through, as well as an msd crank trigger ignition setup with the low pro crab cap distributor, 6al box, and a set of $950 edelbrock stainless upswept dry headers.....
make offers
