That's perfect. I was trying to see what you did to separate the engine compartment. I'm debating whether I should stick with the cocktail seating or go with a bench when I redo the interior.

You guys are doing some great work, keep it up!


Sent from my iPhone using SoCal Jet Boats

Thanks for the compliments! After glassing the tanks and bilge separator in, the floors and stringers were hit with resin. At that point the stringers were done. The floor was sanded as even as possible with 80 grit per AJ at SherFab's instructions. Then the rest was masked and sprayed. The "flowcoat" is a 1:1 mixture of Prestec 27X1 and gelcoat.

I figured I'd bump this since I'll be home in a few days to get the boat put together for the AVI.

Nice looking Eliminator... I had to double take.

Can out so good Jordan! Can't wait to see it at AVI!! 👍👍


"RTCP"