Omar Eliminator tells me that there virtually no differnence from OB, sterndrive and jet hulls ,same goes for the Place craft were about to do !
Greg the transom definately "had wood" ha ha that sucker was no less than 3 inches thick you can see how thick it was proportionate to Rhondas hand in the pic ,guess the installer wanted to help support the "Eggbeater" weight
Jeff are you sure your stringers arent at least similer to the ones shown in the picture ? Tom
...BTW To add some "light" to whats going on here in the photos Josh has stripped away the carpets ,scraped the bilge (carpet adhesive) and layed out /cut out the intake opening for the jet (setback) we'll finish cleaning the used berkeley intake today then mill it to match the bottom and for a ride plate and shoe then we'll set the intake in epoxy and start installing the jet ,note the large holes at all the corners of the cuts these are to radius the corners to avoid 90* corners thus avoiding stress cracking later at these points Josh got to do all the fun stuff I just got to photo, vacuum and draw on the cut-outs
Quote "Give me a Milwaulkee Sawzall and a claw hammer and i'll take down a house!"
