Just bought this boat It looks like a set back intake were can I get a transom cove  or what do I do to make it work


Sent from my iPhone using SoCal Jet Boats

Yes


Sent from my iPhone using SoCal Jet Boats

That out back


Sent from my iPhone using SoCal Jet Boats

Any 1 have something I can  use


Sent from my iPhone using SoCal Jet Boats

Do you have an angle finder?

If not you can download a clinometer for your smart phone.

I may have a fiberglass t/a that will work for you.

Get the angle difference from the pump to the transom.

GT

Sent from my SM-G900V using SoCal Jet Boats mobile app

I actually happen to have my transom plate off my boat right now and it's a 1 piece aluminum unit I can make a paper template and mail it to u if u need


Sent from my iPhone using SoCal Jet Boats

Is there still any of the transom left behind the intake, just behind the shoe? I like about 3/4" of glass remaining at the keel and the rear flange trimmed half way through the last two holes.  Looks like a good solid setback for rough water.  I bet the TA will still register and seal on the suction flange.  I really like that setback because you can still remove the bowl without pulling the TA.

Shitty pic


Sent from my iPhone using SoCal Jet Boats