So Here i am again. tearing into my SWTD once again.
Last summer i ran it really hard knowing the stringers were soft.(bad idea on my part)
I could feel the boat kinda twist out of the hull when i punched it. Plus i could move them from side to side pretty good. AND found cracks along the stringers. So after tom Papp i decided to get to work and replace them.
Also i figured wile i was at it i would put a low pro and do a few other things i couldn't last spring.
Big thanks to TRG, todd for helping me out with this project.
Here we go.





After striping the boat down i took a skill saw to the stringers and bulkheads.











Figured this had something to do with the twisting and what not


Heres what caused it



35 year old firewood and glass

Took a power planer to the wood and blocked it down with 36 grit

Well then the fun part started. Glass. I used 4 layers of 2 oz CSM for this









After all that work I got the new front bulkhead in and primered and blocked down the stringers. Also got the floors nice and flat and shiny

keep up the good work, it's getting there. Seeing other people doing glass work right know helps keep me moving along on my floor, it sucks but i'm not alone...

Thanks bud. Glass work sucks, but it's not that bad. Keep going. You'll be stoked when you're done and you can say you did it your self.

Dude nice work, looks bitchen

Nice good job

Sent from my SGH-T999 using SoCalJetBoats mobile app

Nice job jake, don't know if I woulda done it. That a lot of work

Sweeeet