Evening Gents, I apologize if this is a redundant topic but I was wondering if anyone has come up with an effective fix for rounded of notches on a Place Diverter handle? Other than obviously replacing it

Just on that notch I like the most on top. Corner is a little round

Here you go

http://www.fatboysh2o.com/products/place-diverter-adjustable-7-position-handle-repair-kit

Disclaimer. I have no idea of it works I just saw it on another forum

Let us know how it works out for you

You can tap out the pin with a center punch slightly giving the handle a bit more bite before purchasing the plate.  I did that on a old floor mount one that had worn teeth. seemed to work better... I actually think I tapped the pin completely out an used the other side of pin.

mine is so stiff this last trip  I gave up trying to trim at all  ..  just left in a neutral  position ..  I have a new cable  but have not installed yet .   I hope that will fix it.

More than likely that's your issue. Replace it before the cable breaks!!


Sent from my iPhone using SoCal Jet Boats