Do any of you have pics of where and how you mounted your kill switches?

Do any of you have pics of where and how you mounted your kill switches?

There's a couple of ways you can do this the easiest is the positive wire running to the coil,you can buy the switch at your loco auto parts store,the switch goes in between the the coil wire wright behind the dash,so for a clean set up your going to have to drill a hole in the dash mount it some easy to get to fairly easy. good luck

That might work, much easier if you go off the ignition wire save you some time the wires are already their  just my o2

Old school kill switches for mags were real simple.  Replace your button with a water proof toggle. and add an Eye Bolt about an inch to the "engine off" side.  Put a loop in your lanyard and thread it through the eye bolt and over the toggle.  Tie the lanyard to your jacket and go racin. Toggle away from eye bolt, motor on. Toggle toward eye bolt, motor off. Driver leaves the vicinity toggle gets pulled toward eye bolt, motor off. be sure you leave enough slack in the lanyard so it doesn't go motor off if you move a bit in the seat.

Sorry, should have posted yesterday. Mounted the kill switch to the front of the seat pedistal, then ran the wires in a piece of 3/8 fuel line under the seat and up to the wiring harness.  Ron