TIG torch Holder...

« **on:** October 11, 2010, 04:16:30 PM »

I made this magnetic tig torch holder to prevent me from breaking cups and laying to hot torch on something it should not be touching where the tungsten would get contaminated. I epoxied an earth magnet in a pocket I machined in the bottom of the base. It works great.
T.J.

« **Reply #1 on:** October 12, 2010, 09:11:42 PM »

Verrrry nice!

But I notice a problem with your workbench. It's too clean.

« **Reply #2 on:** October 12, 2010, 11:02:51 PM »

Quote from: Stevecat on October 12, 2010, 09:11:42 PM

Verrrry nice! But I notice a problem with your workbench. It's too clean.

I was diggin' the hell out of the hunk of Romex jammed into the outlet.

He is human after all folks...

You mad skills make me feel inadequate in so many ways...

GT

« **Reply #3 on:** October 13, 2010, 08:00:34 PM »

? that wouldn't work for me have a s.s top but that is a awsome holder.how do you like the liquid cooled machine do you like it better than the other iv'e got a miller maxstar 200 not bad machine have not played with alum. but i think i need a high freq welder right good job i'm for sure amaze with things you make. keep making things so i can TRY to copy thanks

rusty

« **Reply #4 on:** October 13, 2010, 08:05:06 PM »

My machine is a Dynasty 300DX. To do alum you need A/C. I think the maxstar is just DC. No sure though. The water cooled torch is great. I would never go back to air cooled. The water cooled torch is nice and small compared to an air cooled one too.
Thanks.
T.J.

TJS Nordic

TIG torch Holder...

Stevecat

Re: TIG torch Holder...

GT Jets

Re: TIG torch Holder...

GreatLakes Jet

Re: TIG torch Holder...

TJS Nordic

Re: TIG torch Holder...