When you pull something off for the first time and it looks like this


Sent from my iPhone using SoCal Jet Boats

If that's how it's suppose to look, Nice hole, if not then damn that sucks!

What did they cut that hole with? a shovel?

it looks like they used a chisel and a hammer 


Sent from my iPhone using SoCal Jet Boats

Where would I find the parts to make my steering Bessel longer ?


Sent from my iPhone using SoCal Jet Boats

CP performance?
Jet Boat Performance?
Rex Marine?
ARS?
Eddie?

There's probably more

Dan'l
 

I guess what I ment to ask is what all do I need?



Sent from my iPhone using SoCal Jet Boats

like this?

http://www.cpperformance.com/c-792-steering-wheel-hubs-adapters-bezels.aspx

or this?

http://www.cpperformance.com/p-73996-billet-aluminum-6-bolt-one-piece-steering-wheel-adapter-585.aspx

Dan'l

Yea something like the 8" do I need to also get a longer shaft ? Because wouldn't the longer bezel move the shaft adapter and shaft further away from the helm ?


Sent from my iPhone using SoCal Jet Boats

Looks like it bolts on to the 3/4"tapered shaft. Looks like you have the old school square shaft on your helm. May need to upgrade that old steering system to the teleflex rack and pinion unit, too.

What steering wheel are you using?

Dan'l

I hope it goes without saying,  but going to say it.

That dash needs to be redone with new wood and glass to restore the strength before an extension can be installed.

Otherwise it's just unsafe.

GT

so the whole dash needs to be cut out ??


Sent from my iPhone using SoCal Jet Boats

so the whole dash needs to be cut out ??


Sent from my iPhone using SoCal Jet Boats

No, not at all.

There should be a piece of plywood backing that dash up,  that should really be replaced. Then once the new wood is laminated in,  fresh holes drilled through the repaired fiberglass.

GT