Bump


Sent from my iPhone using SoCal Jet Boats

Good luck! I've been looking for a while and haven't found anything decent. I'm probably gonna have to drop $1200 on a new set from bassett.

I know the feeling and will probably go with set of Rewarders. I'm about a month away from needing them. Us small motor guys have it rough haha


Sent from my iPhone using SoCal Jet Boats

im thinkin about buying a set of the schoenfields for my float

Speedway- http://www.speedwaymotors.com/Small-Block-Chevy-Sprint-Roadster-Headers-Chrome,34430.html

Schoenfeld- http://www.schoenfeldheaders.com/sprintdyno4.html

I have both schonfeld and rocket stainless sprint car headers -not for sale- on mine.

Dan'l

Thanks for the links! Do you have a picture of them on the boat?


Sent from my iPhone using SoCal Jet Boats

I was wondering the same thing. Can I just flip them?

If you have the standard Chevy header flange where the bolts are in the center, you should be able to flip them.
Now that I think about it, I'm pretty sure I can just flip my Stahl flanges and they should fit for me too without doing anything special.



Sent from my iPhone using SoCal Jet Boats

Schoenfeld makes sbc boat headers in different sizes.

http://www.schoenfeldheaders.com/boatmarine.html


Sent from my iPhone using SoCalJetBoats mobile app

This might be the way I go. Just not sure I want to run dry headers. Thanks for the info.

Would you happen to have a picture handy so I could see your setup?

I'm sorry I don't.

I just bought 8 1/8 npt steel bungs and drilled holes and welded them into the primaries.

I also drilled 1/8" holes in the bottom most point of the primary tubes for weep holes

Then I bought 1/8 npt to -3an fittings and screwed them in

Sounds easy enough.  Thank you.

Awsome.  Thanks again Steve

No problem

Incase you didn't know. Mcmaster carr is the shit!  Their prices are great,  and we get their stuff in one day. They are in city of industry

Their shipping is usually 5 bucks or so

Yeah McMaster is solid, they have bailed us out at work plenty of times.

Schoenfeld makes sbc boat headers in different sizes.

http://www.schoenfeldheaders.com/boatmarine.html


Sent from my iPhone using SoCalJetBoats mobile app

I went ahead and ordered the Schoenfeld headers. They are quite nice for the price. I couldn't find any actual pictures of them on an engine before I ordered, so I'll put these up for someone who may be kicking it around. These are the 1-3/4"-1-7/8" stepped. ONE day I'll have a picture of them in the boat...


Sent from my iPhone using SoCal Jet Boats

I had to adjust mine, they were a lil to close to the transom.

Yeah they look a little close haha. I measured and should have a couple inches. We'll see


Sent from my iPhone using SoCal Jet Boats